Pages: [1]   Go Down

Author Topic: Lightroom and Logitech SetPoint conflict  (Read 3214 times)

allan67

  • Jr. Member
  • **
  • Offline Offline
  • Posts: 69
    • http://
Lightroom and Logitech SetPoint conflict
« on: May 13, 2007, 11:38:32 am »

I've identified a strage conflict between LR and Logitech's SetPoint software (ver 3.3). It's all on WinXP SP2.
When SetPoint is loaded, which allows for advanced functionalities in mouse to be used (I have MX Revolution), LR does not launch at all. There's no error message, no splash screens, no freezing - just nothing happens.
When I close SetPoint (from Task tray icon) - LR starts without any problem. But then I can use only basic mouse functions, which are probably catered for by the system itself.

Anybody else saw this behaviour? I've tried searching on Internet, but can't find anything about this problem.
Any help very welcome.
Allan
Logged

pmik

  • Newbie
  • *
  • Offline Offline
  • Posts: 2
Lightroom and Logitech SetPoint conflict
« Reply #1 on: May 30, 2007, 12:44:38 pm »

Yes, I see exactly the same behavior. Anybody with good ideas? If I start Logitech Setpoint after Lightroom, then it works fine. My Setpoint version is 3.30.165.
peter
Logged

Tom Perkins

  • Newbie
  • *
  • Offline Offline
  • Posts: 26
    • http://www.tomperkinsphotography.com
Lightroom and Logitech SetPoint conflict
« Reply #2 on: May 30, 2007, 02:20:26 pm »

I guess this is only with the later versions of setpoint, I am using a g5 mouse with version 2.42.247 (have never updated) and lightroom works fine.

edit: I'm on XP too.
« Last Edit: May 30, 2007, 02:21:18 pm by Tom Perkins »
Logged
Pages: [1]   Go Up