Flickering screen when using NIKplugins

[zobelaudio]

Hi guys,

Whenever I use DXO-NIK in PS and also DaVinci, my screen flickers and sputters.
DXO is aware of the problem but has no solution. Do you think I can/should update the driver and if possible, how do I do this. Can't find anything on the AMD website.
Is is very annoying, because everything else is just fine.
Oh and I use an EIZO CG318 with a 2013 Mac Pro.
Any thoughts or tips ?
cheers, Stephan

[degrub]

just some general ideas  =
1) does the same issue occur with another screen over the same cables at the same resolution/bit rate ?
2) does the same issue occur with the CG screen over different interface ( HDMI versus DP) ?
3) does the issue occur if you move cables to another port of same type ?
4) is anything else plugged into the ports on the CG ?  unplug. Anything else plugged into the same display output controller on the MP ? unplug
4a) is the video signal passing through a "docking station" device ? try direct to the CG. i have seen multiple issues with these loosing sync
5) does the issue still occur if you reduce the output resolution from the MP or the display screen resolution setting  ?

6) did the issue coincide with a software update ? roll back and see if it goes away.

[zobelaudio]

lot's of questions Dr degrub ...but thx, I'll check and report back. Never tried all this since my system as far as periphery goes has been the same and the problem stared a while ago. I think it was not related to the OS version.

[zobelaudio]

checked everything but the "other monitor stuff"
So not connection related. May the graphics card be at some sort of limit ?