Some roll papers are not available in 24" length, only 44". Any suggested methods for cleanly cutting 44" rolls for use in 24" printers?
Which particular papers are you not finding in 24" width?Brian.
You could use a sliding 12" chop saw or a radial arm saw. Either should use fine 80 - 100 carbide tooth virgin blade i.e. buy the blade and only use it for paper or canvas cuts.
One is the Hiromi Asuka papers, only available in 44", I may be using this paper for an extended project.
Hi Shaun, yes not the run of the mill common paper, if you haven't purchased a new 24" printer yet and you have the space why not consider a 44" printer not often do you hear "wish I had bought a smaller printer" but more likely wishing one had bought a wider printer, looking at your website images I can imagine them printed large, wonderful portfolio of Antarctic images.Brian.