Pages: [1]   Go Down

Author Topic: Dev. Mod to Print Mod. Issue!  (Read 889 times)

ajz

  • Jr. Member
  • **
  • Offline Offline
  • Posts: 58
Dev. Mod to Print Mod. Issue!
« on: March 04, 2015, 01:49:47 pm »

Recently, any image sent from the Develop Module to the Print Module is not the same image . It is always the FIRST image in a Folder that is transferred over to the Print Mod. This happens no matter what LR Folder is  selected. This has not happened previously. Been shooting in Cuba, returned after two weeks and this issue has just happened. Running LR 5.7.1. The MacPro is only running LR. Nothing has been changed recently except the import of Cuba photos. Same happens with earlier LR Cat always the FIRST image in the Folder showing up in the Print Mod. . Also Re-installed LR5 - same issue happens.

Seems to be a LR issue but cannot figure what is happening nor why. Issue has never occurred before.

Any thoughts would be most appreciated.
Logged

JeanMichel

  • Sr. Member
  • ****
  • Offline Offline
  • Posts: 503
Re: Dev. Mod to Print Mod. Issue!
« Reply #1 on: March 04, 2015, 04:56:50 pm »

Hi
You probably have all your images selected. If that is so, when you go to Print all the images, starting with the first one would be sent to the printer. Make sure that you only have one image selected when developing.
Jean-Michel
Logged

ajz

  • Jr. Member
  • **
  • Offline Offline
  • Posts: 58
Re: Dev. Mod to Print Mod. Issue!
« Reply #2 on: March 04, 2015, 08:09:11 pm »

Thank you...I missed that "selection" in the Print Module...must have changed it at some point.

thank you,

aj
Logged
Pages: [1]   Go Up