Pages: 1 [2]   Go Down

Author Topic: Z3200 on Everyday Satin noGloss. B&W prints too dark?  (Read 4787 times)

Phil Indeblanc

  • Sr. Member
  • ****
  • Offline Offline
  • Posts: 2017
Re: Z3200 on Everyday Satin noGloss. B&W prints too dark?
« Reply #20 on: December 21, 2014, 04:16:41 pm »

Yes...and I know this better, but until I replace part of my brain with a computer, I will have to share my experiences with such a wonderful stage and people :-)
And it makes life more meaningful.
Logged
If you buy a camera, you're a photographer...

rubencarmona

  • Newbie
  • *
  • Offline Offline
  • Posts: 28
Re: Z3200 on Everyday Satin noGloss. B&W prints too dark?
« Reply #21 on: December 22, 2014, 05:07:27 am »

Also, be sure you keep a constant room light where you edit your pictures on a screen and be sure you calibrate compensating the ambient light.

Therefore use a colorimeter with ambient light sensor (Spyder4Pro, Spyder4Elite, ColorMunki Display, i1 Display Pro)
Logged

Phil Indeblanc

  • Sr. Member
  • ****
  • Offline Offline
  • Posts: 2017
Re: Z3200 on Everyday Satin noGloss. B&W prints too dark?
« Reply #22 on: December 23, 2014, 11:50:16 am »

As long as you keep light off the screen and the room is darker than your screen, which I keep it on cavernous side, you should be good.
If you have to have it close to a light source/window, have a hood on the screen or something to block directional light.

I have been using the Spyder3 Elite for about ?/+5years since it was available on another couple screens....It too has a ambient light sensor.

Logged
If you buy a camera, you're a photographer...

Phil Indeblanc

  • Sr. Member
  • ****
  • Offline Offline
  • Posts: 2017
Re: Z3200 on Everyday Satin noGloss. B&W prints too dark?
« Reply #23 on: December 29, 2014, 07:29:17 pm »

thank you!
Logged
If you buy a camera, you're a photographer...
Pages: 1 [2]   Go Up