Topic: P45 Capture Count (Read 3523 times)

lightsong · « **on:** February 17, 2009, 04:31:02 pm »

How do I determine the capture count on a Phase One P45 digital back?

Thanks,
John

DavidP · « **Reply #1 on:** February 17, 2009, 05:09:51 pm »

Under Menu go to Configuration, scroll all the way down to About, and See Count. This is the capture count, as far as I know only the factory can reset it.
According to Phase, it almost does not matter what the count is as there are basically no moving parts.

lightsong · « **Reply #2 on:** February 18, 2009, 02:47:57 pm »

Quote from: DavidP

Under Menu go to Configuration, scroll all the way down to About, and See Count. This is the capture count, as far as I know only the factory can reset it.
According to Phase, it almost does not matter what the count is as there are basically no moving parts.

Thanks David. I agree but sellers on ebay have shown it so I thought I should do the same.

John

micmatthews · « **Reply #3 on:** February 20, 2009, 09:51:15 am »

The reason Phase One capture count does not matter is because there are no moving parts inside. Phase One uses what they call
sleeping architecture. The back go to sleep in between captures. Due to not having moving parts like a car for example the capture
count does not matter.

Author Topic: P45 Capture Count (Read 3523 times)