Pages: [1]   Go Down

Author Topic: Manual focus vs auto  (Read 8770 times)

dwdallam

  • Sr. Member
  • ****
  • Offline Offline
  • Posts: 2044
    • http://www.dwdallam.com
Manual focus vs auto
« on: October 16, 2007, 05:46:48 am »

After reading the other new thread on DSLR focusing, I had some questions.

First, and correct me if I'm wrong here, but a camera's autofocus is limited in range?

If so, and you need to focus on something 200 yards in the distance, how does autofocus focus, and it does?

Second, how accurate is autofocus when it actually gets a lock? Can we as humans manual focus as accurately as autofocus? Let's assume autofocus is set to ONE point, not several to avoid averaging.
Logged

Monito

  • Jr. Member
  • **
  • Offline Offline
  • Posts: 97
    • MonitoPhoto
Manual focus vs auto
« Reply #1 on: October 16, 2007, 06:07:02 am »

Quote
After reading the other new thread on DSLR focusing, I had some questions. First, and correct me if I'm wrong here, but a camera's autofocus is limited in range? If so, and you need to focus on something 200 yards in the distance, how does autofocus focus, and it does? Second, how accurate is autofocus when it actually gets a lock? Can we as humans manual focus as accurately as autofocus? Let's assume autofocus is set to ONE point, not several to avoid averaging.[a href=\"index.php?act=findpost&pid=146313\"][{POST_SNAPBACK}][/a]
Autofocus works by analyzing the image that comes through the lens.  It essentially does a contrast comparison.

Thus the system is not limited by the distance of the object, but only by the focus range of the lens.  Most lenses can focus on the moon (infinity), and the autofocus can bring it into focus.

Autofocus is accurate according to the depth of field, mainly.  If the depth of field is small because of a combination of wide aperture, close focus distance, high degree of enlargement of the print, and a close viewing distance, then the autofocus may appear to be inaccurate.  On the other hand, if the picture is taken at f/8 with a "normal" focal length on a modest sized sensor or film (i.e. not 11x14 inch film) at, say, full length figure distance and an 8x10 inch print is viewed at arms length, then the autofocus system should have zero difficulty focusing in reasonable light.

Humans have difficulty focusing as well as autofocus if a) the light is bad, b) the viewfinder is small (think 1.5 or 1.6 crop factor), c) the requirements are critical (gallery quality large prints viewed at close distances), or d) the action is fast and unpredictable.  These situations may be difficult for autofocus systems too, but they tend to exceed human capabilities in many marginal situations.
Logged

dwdallam

  • Sr. Member
  • ****
  • Offline Offline
  • Posts: 2044
    • http://www.dwdallam.com
Manual focus vs auto
« Reply #2 on: October 16, 2007, 06:35:17 am »

So how close does autofocus get to "true" focus in a best csae situation, such as you pointed out above, f8 in good light at 50mm, for instance? I guess a better way to put it should be to say if autofocus focuses, and it looks focused in the viewfinder to the naked eye, is that as good or better than one could do manually?

Quote
Autofocus works by analyzing the image that comes through the lens.  It essentially does a contrast comparison.

Thus the system is not limited by the distance of the object, but only by the focus range of the lens.  Most lenses can focus on the moon (infinity), and the autofocus can bring it into focus.

Autofocus is accurate according to the depth of field, mainly.  If the depth of field is small because of a combination of wide aperture, close focus distance, high degree of enlargement of the print, and a close viewing distance, then the autofocus may appear to be inaccurate.  On the other hand, if the picture is taken at f/8 with a "normal" focal length on a modest sized sensor or film (i.e. not 11x14 inch film) at, say, full length figure distance and an 8x10 inch print is viewed at arms length, then the autofocus system should have zero difficulty focusing in reasonable light.

Humans have difficulty focusing as well as autofocus if a) the light is bad,  the viewfinder is small (think 1.5 or 1.6 crop factor), c) the requirements are critical (gallery quality large prints viewed at close distances), or d) the action is fast and unpredictable.  These situations may be difficult for autofocus systems too, but they tend to exceed human capabilities in many marginal situations.
[a href=\"index.php?act=findpost&pid=146314\"][{POST_SNAPBACK}][/a]
Logged

Jonathan Wienke

  • Sr. Member
  • ****
  • Offline Offline
  • Posts: 5829
    • http://visual-vacations.com/
Manual focus vs auto
« Reply #3 on: October 16, 2007, 11:17:30 am »

I hardly ever focus manually with my 1-series cameras because AF is faster and more accurate. The main exception is when AF focuses on the wrong thing and I have to override it.
Logged

djgarcia

  • Sr. Member
  • ****
  • Offline Offline
  • Posts: 341
    • http://improbablystructuredlayers.net
Manual focus vs auto
« Reply #4 on: October 16, 2007, 03:06:20 pm »

It also depends on the type of photography you're doing at the time. For landscapes on a tripod, the AF goes off for me. But it's back on as soon as the camera is off the tripod.
Logged
Over-Equipped Snapshooter - EOS 1dsII &

dwdallam

  • Sr. Member
  • ****
  • Offline Offline
  • Posts: 2044
    • http://www.dwdallam.com
Manual focus vs auto
« Reply #5 on: October 16, 2007, 08:28:43 pm »

That's pretty much my usage too.

Quote
It also depends on the type of photography you're doing at the time. For landscapes on a tripod, the AF goes off for me. But it's back on as soon as the camera is off the tripod.
[a href=\"index.php?act=findpost&pid=146422\"][{POST_SNAPBACK}][/a]
Logged

wturber

  • Newbie
  • *
  • Offline Offline
  • Posts: 8
Manual focus vs auto
« Reply #6 on: October 17, 2007, 08:24:05 pm »

Quote
After reading the other new thread on DSLR focusing, I had some questions.

First, and correct me if I'm wrong here, but a camera's autofocus is limited in range?

If so, and you need to focus on something 200 yards in the distance, how does autofocus focus, and it does?

Second, how accurate is autofocus when it actually gets a lock? Can we as humans manual focus as accurately as autofocus? Let's assume autofocus is set to ONE point, not several to avoid averaging.
[a href=\"index.php?act=findpost&pid=146313\"][{POST_SNAPBACK}][/a]

DSLR autofocus uses phase detection.  That's a fancy way of saying "rangefinder."

Basically, an AF sensor simultaneously looks through your lens out of two opposite sides of the lens' exit pupil.  Its sensors are long thin strips, so it sees a pattern on two strips.  It analyzes these patterns and then calculates how far their offset ffrom each other.  That lets the camera know how far to move the lens in order to get them to line up perfectly - which equates to good focus.  The AF makes that calculation and sends to order to move the lens the appropriat amount  and voila - you have focus.  Some AF systems might do a double-check and either re-check the AF sensors (not likely) or more likely verify that the lens was actually moved where it was supposed to go.  I notice that my Olympus DSLRs will sometimes make a little micro adjustment after the main focus movement.  It is this basic mode of look once and then move the lens that makes phase detect faster than the contrast detect in compact cameras.  Contrast detect uses a form of trial and error.  Phase detect makes one reading and ideally calculates how much and in what direction to move the lens.

Each AF sensor looks out the exit pupil at positions that correlate to different f-numbers.  The smaller the f-number, the greater the precision because your "rangefinder" is working with an effectively larger base to its triangle.  The more expensive DSLRs have higher precision f/2.8 sensors, as well as f/5.6 sensors.  This, BTW, is why AF doesn't usually work much past f/5.6.  The AF sensors are trying to look out an f/5.6 window that isn't there.  Likewise, the higher precision f/2.8 sensors are of no benefit when an f/4 lens is used.  FWIW, the Canon 1D-MIII has four different precisions in its AF sensors: f/2.8, f/4, f/5.6, and one f/8 sensor.

So, given you are using lenses that aren't faster than the sensors in your camera, you should have pretty accurate AF.  At least that's true if your camera and lenses are calibrated well.  Remember that one big AF move?  Part of that includes some camera/lens intelligence on the inertial overshoot to expect with a given lens and degree of movement. There is also the bit about spherical aberration.  If you are shooting with a lens that has a lot of spherical aberration what looks like good focus at the f/2.8 may not be good focus at f/4. So errors can creep in there too.

With faster lenses shot at fast apertures, the spherical aberration bit can be a much bigger problem if you are shooting at an aperture significantly faster than the camera's AF sensors.  If you pop a fast f/1.4 lens on a budget DSLR that only has f/5.6 precision sensors, you could be in trouble.  Maybe not if the lens has minimal spherical aberration.  But if it has lots, then you may never be happy with the focus.

My experience with Olympus DSLRs is that the most accurate focus comes from using 10x Liveview manual focus, AF with Olympus ZD lenses is next, split prism manual focus after than, then comes AF confirm with manual lenses (using a Panasonic DMC-L1, and last in line is manual focus using the standard focus screen.  Different users with different eyes, lenses and cameras may find a somewhat different order.
Logged

dwdallam

  • Sr. Member
  • ****
  • Offline Offline
  • Posts: 2044
    • http://www.dwdallam.com
Manual focus vs auto
« Reply #7 on: October 18, 2007, 03:42:19 am »

Quote
DSLR autofocus uses phase detection.  That's a fancy way of saying "rangefinder."

[a href=\"index.php?act=findpost&pid=146776\"][{POST_SNAPBACK}][/a]

Good information. Thanks.

So what are your methods of manual focusing?

What I do is bring the lens obviously out of focus then slowly back into focus, and then keep going until I see it go out of focus again, then slightly back just a little out of focus and then back and forth like that until I can't tell any difference. That's "focus" for me. So in other words, I just use a back and forth motion using smaller and smaller movements until I can no longer see anything that looks like it is out of focus.
« Last Edit: October 18, 2007, 03:43:08 am by dwdallam »
Logged

Rob C

  • Sr. Member
  • ****
  • Offline Offline
  • Posts: 25209
Manual focus vs auto
« Reply #8 on: October 18, 2007, 12:03:00 pm »

Another thing that complicates life is that lenses can exhibit focus shift on stopping down; makers claim to have eliminated this but I often wonder...

Rob C

Gregory

  • Full Member
  • ***
  • Offline Offline
  • Posts: 191
    • http://www.gregory.hk
Manual focus vs auto
« Reply #9 on: October 18, 2007, 12:46:15 pm »

Quote
Another thing that complicates life is that lenses can exhibit focus shift on stopping down; makers claim to have eliminated this but I often wonder...
OUCH!
Logged
Gregory's Blog: [url=http://www.gregory.

Rob C

  • Sr. Member
  • ****
  • Offline Offline
  • Posts: 25209
Manual focus vs auto
« Reply #10 on: October 31, 2007, 03:53:22 pm »

Quote
OUCH!
[a href=\"index.php?act=findpost&pid=146960\"][{POST_SNAPBACK}][/a]

Gregory - sorry this seems to have killed the thread stone dead, but there you are, no total solutions ever exist, at least not in photography as I know it!

Rob C

kitalight

  • Jr. Member
  • **
  • Offline Offline
  • Posts: 72
Manual focus vs auto
« Reply #11 on: November 15, 2007, 12:21:46 am »

Quote
After reading the other new thread on DSLR focusing, I had some questions.

First, and correct me if I'm wrong here, but a camera's autofocus is limited in range?

If so, and you need to focus on something 200 yards in the distance, how does autofocus focus, and it does?

Second, how accurate is autofocus when it actually gets a lock? Can we as humans manual focus as accurately as autofocus? Let's assume autofocus is set to ONE point, not several to avoid averaging.
[a href=\"index.php?act=findpost&pid=146313\"][{POST_SNAPBACK}][/a]

The farther away the point of focus the more DoF and thus the less precise the AF...AF lenses don't manually focus as easily/as well as MF lenses designed for MF because the latter's focusing barrel has a long ratio "turning radius" for more critical focusing within the DoF...AF focusing barrels' "short ratio" rotation are designed for quick AF and in MF the Point of Focus is easily passed making it difficult to fine focus around the exact PoF.
Logged

dwdallam

  • Sr. Member
  • ****
  • Offline Offline
  • Posts: 2044
    • http://www.dwdallam.com
Manual focus vs auto
« Reply #12 on: November 15, 2007, 02:17:49 am »

Quote
The farther away the point of focus the more DoF and thus the less precise the AF...AF lenses don't manually focus as easily/as well as MF lenses designed for MF because the latter's focusing barrel has a long ratio "turning radius" for more critical focusing within the DoF...AF focusing barrels' "short ratio" rotation are designed for quick AF and in MF the Point of Focus is easily passed making it difficult to fine focus around the exact PoF.
[a href=\"index.php?act=findpost&pid=152970\"][{POST_SNAPBACK}][/a]


Well, that is quantifiable, and although I do not own a purely manual focus lens, I can attest to the fact that the sweet spot on all my auto lenses is quite small, as you state. Thanks for that information.
Logged
Pages: [1]   Go Up