Filling in a background....what's the best way?

[Dinarius]

I laid out a roll of 5 foot white paper on the ground and placed an item of furniture on it.

I then shot the furniture from overhead.

However, the white paper does not extend the edge of the frame and I would like it to.

The white paper is evenly lit.

What is the best way of 'extending' the white paper to fill the frame? I could go mad with the Clone tool, but there must be a neater way?

Many thanks.

D.

[craigwashburn]

I laid out a roll of 5 foot white paper on the ground and placed an item of furniture on it.

I then shot the furniture from overhead.

However, the white paper does not extend the edge of the frame and I would like it to.

The white paper is evenly lit.

What is the best way of 'extending' the white paper to fill the frame? I could go mad with the Clone tool, but there must be a neater way?

Many thanks.

D.
[a href=\"index.php?act=findpost&pid=127592\"][{POST_SNAPBACK}][/a]

I just select a chunk of the white, copy and paste, smooth over any seams with healing brush.

or just clip the piece out and place on a new blank image that is rgb white.

[Gordon Buck]

Use two sheets of the white paper and then clone away the "seam" between them; or use three sheet and clone away the two end seams.

[Ed Foster, Jr.]

I laid out a roll of 5 foot white paper on the ground and placed an item of furniture on it.

I then shot the furniture from overhead.

However, the white paper does not extend the edge of the frame and I would like it to.

The white paper is evenly lit.

What is the best way of 'extending' the white paper to fill the frame? I could go mad with the Clone tool, but there must be a neater way?

Many thanks.

D.
[a href=\"index.php?act=findpost&pid=127592\"][{POST_SNAPBACK}][/a]

D.
Perhaps you could use the rectangular marquee tool in PS, select as much of the white as possible, and then use Edit>Free Transform to extend the white background area selected to the edge of the frame.

Good Luck,
Ed

[Alaska]

Ed:

There are about as many ways to extend the white as there are copies of PS.  You could use Image > Canvas Size and just add to either the left/right or top/bottom.  Or all four sides in white.  

If you need 2 inches on the left and right place a 4 in the box and select inches.  If the foreground color is white then select foreground.  If not then background or white.

Select a brush, white and paint in any areas that requires white.  A better approach is to add a layer above your image and paint on that.  This way the painting can be removed or changed in opacity or fill and it does not destroy your image.

Jim