Doing a quick, intensive print job for a gallery on their very much new P8000.
We've run through about four 24" rolls of German Etching, so have run out down the starter carts, on most channels, but switched them before empty. Printer is now doing nozzle checks and head cleans after pretty much every other print. No visible head strikes, but manual nozzle check prints after every half dozen prints are showing slight defects, not visible in the outputs. Checks absolutely clean after auto head clean.
Prints are not heavy ink usage, A1 size.
I've been Canon for the last decade, with the exception of a Piezography 7880, and a surelab d800. Before that, a decade of mid to large Epson aqueous.
Temperature is around 75F, RH around 40-50%
Next printing session starts again tomorrow morning (about eleven hours from now...).
Normal behaviour?
Anything I should be doing?