Pages: [1]   Go Down

Author Topic: What happened to straighten tool?  (Read 1528 times)

kevs

  • Sr. Member
  • ****
  • Offline Offline
  • Posts: 932
What happened to straighten tool?
« on: November 20, 2020, 07:43:01 pm »

I can't find this anymore, "straighten" . I posted in Adobe forum but getting a long winded detour into the complex geometry panel, so I'm exasperated, thanks!
Logged
Canon 5DS4/ 5D2/ Canon 16-35, 24-105, fixed 85, Profoto D1s

elliot_n

  • Sr. Member
  • ****
  • Offline Offline
  • Posts: 1219
Re: What happened to straighten tool?
« Reply #1 on: November 20, 2020, 07:53:51 pm »

It's now in the crop tool.
Logged

kevs

  • Sr. Member
  • ****
  • Offline Offline
  • Posts: 932
Re: What happened to straighten tool?
« Reply #2 on: November 20, 2020, 08:09:04 pm »

Thanks Eliot ok found it.

Question: It often over/ undershoots, so just have to command z and keep trying right?  But when I let go of tool, the tool unselected, and then click on it many times. Is there way to have to tool active until I say otherwise?
Logged
Canon 5DS4/ 5D2/ Canon 16-35, 24-105, fixed 85, Profoto D1s

elliot_n

  • Sr. Member
  • ****
  • Offline Offline
  • Posts: 1219
Re: What happened to straighten tool?
« Reply #3 on: November 21, 2020, 03:09:10 pm »

I'm not sure what you mean by over/under-shooting. If you select the tool and use the ruler to draw a line on the image, then that line will be rendered straight. Or you can double-click on the tool to have ACR try to figure it out for itself. If you don't like the result use the 'angle' slider to adjust (or use the up and down cursor keys).
Logged

kevs

  • Sr. Member
  • ****
  • Offline Offline
  • Posts: 932
Re: What happened to straighten tool?
« Reply #4 on: November 21, 2020, 04:53:27 pm »

Elliot thanks excellent. Angle slider, excellent, when was that introduced?, never seen it before. great
Logged
Canon 5DS4/ 5D2/ Canon 16-35, 24-105, fixed 85, Profoto D1s
Pages: [1]   Go Up