Pages: [1]   Go Down

Author Topic: z3200 24" line error and color error.  (Read 277 times)

lcastric

  • Newbie
  • *
  • Offline Offline
  • Posts: 31
    • http://www.lincolncastricone.com/blog
z3200 24" line error and color error.
« on: February 10, 2018, 01:37:51 PM »

I have taken apart my z3200 to replace an electronics board, which ultimately was the main logic board.
The printer initialized and seemed to be running normally except for two errors indicating issues with the line and color sensors.
My question is: are these sensors sensitive to stray light, IOW should I put the printer back together to perhaps resolve these issues or
work on the sensors first? The line sense is a deal breaker because I cannot load any paper to finish the setup process. Thanks for you help
Logged

Mark Lindquist

  • Sr. Member
  • ****
  • Offline Offline
  • Posts: 1301
  • itís not about the photos we take - itís the ones we leave
    • LINDQUIST STUDIOS
Re: z3200 24" line error and color error.
« Reply #1 on: February 13, 2018, 04:42:59 PM »

I have taken apart my z3200 to replace an electronics board, which ultimately was the main logic board.
The printer initialized and seemed to be running normally except for two errors indicating issues with the line and color sensors.
My question is: are these sensors sensitive to stray light, IOW should I put the printer back together to perhaps resolve these issues or
work on the sensors first? The line sense is a deal breaker because I cannot load any paper to finish the setup process. Thanks for you help

Yes - make sure the sensors (limit switches) are all correctly installed and and the printer is put back together correctly. You've actually answered your own questions.

Logged
Mark Lindquist
z3200.com, MarkLindquistPhotography
Pages: [1]   Go Up