The Flash on Canons are ONLY fil flash, unless you shoot the flash in manual mode or use the FEC on the flash to dial up the power more. Remember too that small flashguns are not a science, and if you are getting good results using one, that's about all you can hope for. If you want more control, use a stand and light meters with dedicated strobes. As stated, you can use the flashe's FEC to give a main light effect, not just a fill. Once you get use to using teh 580's FEC, the gun is actually QUITE flexible. I give Canon a 99% on that one. I ahted it when I first got mine, but a few days later after reading up and understanding it, I began to really apprecaite its technology.
Remember also that when you change the camera's suggested exposure, by turning the dial on the back, it does not reset itself after each shot, and not even after you turn the camera off. Also, when you meter, try aiming the camera at the least dark or light aspect of the shot. Aim teh camera at teh middle contrast area, not teh exposure, then set it mauanlly. If you aim it at the lighter side or darker side of the shot, then you will get corresponding ligher or darker suggestions from the camera when the constrast is greater than the camera can record. In otehr words, you fool the camara's technical ability.
Last, if it gives you underexposed suggestions, just dial up the EC a little and don't worry about it unless you know that the exposure is definitely off. Then you need to return the camara for service.
Sometimes when shooting sunsets, I get the same thing. However, I know it's not a defect. It's simply the meter reading a part of the sky that is bright or dark and it isn't analyzing the scene lie my eye can. It thinks it needs too much or not enough exposure. I've also noticed that exposure from the camera is only a starting point. The most used aspect of my Canon is the EC speed ring on its back. That thing is gonna wear out before the shutter does. I'm all over it.
I have a lot of respect for film shooters who never had a LCD or histogram. For digital shooters, exposure problems are pretty much a problem of the past, after you understand how your camera works and what you need to do to get a good exposure.
Still, it is possible that your camera is defective. Make sure you have the mtering mode set correctly before you get uptight about it. There are three possible metering settings for the 20D. Your manual can guide you there. Play with it and see what happens.
I have noted majority of my exposures with my Canon 20D are under-exposed. This is especially true with my Canon 580EX flash. I have already checked the exposure compensation and all possible causes which may cause this problem. I believe this maybe an error in camera processing algorithms. Has anyone else encountered this problem?
[a href=\"index.php?act=findpost&pid=68916\"][{POST_SNAPBACK}][/a]