Hello, I'm looking for best way to read targets with i1iO.
Target generation:
i1Profiler uses all patches in a target to generate a profile, uses thin white and normal black separators
Colorport uses all patches in a target to generate a profile, uses multicolor separators
Profilemaker Measuretool5 uses some patches to detect errors (how many etc, I don't know), uses normal blak and white separators.
Target reading:
i1Profiler has so far unreliable target reading, frequent pauses, re-reads some strips that are fine.
Colorport has normal reading, with occasional slower reading certain rows.
Profilemaker Measuretool5 has so far best reading ability, with errors detection refuses to read bad targets at all, like cmyk target that was printer in a wrong way.
So the questions is:
Is optimal to use Profilemaker Measuretool5 to read i1Profiler targets? Perhaps it is better to use colorport, but then there is no error detection at all. It is possible to end up building a profile for wrongly printed target.
Isn't using Profilemaker Measuretool5 to measure targets built with other software means there is no error detection as these targets will not contain normal "error detection (blue color?)" patches to begin with?
Thank you.