i am using an HP Z3200 printer. If i wanted to cut a 24" wide roll into a 13" and 11" rolls what would be the cleanest method? i was thinking of a bandsaw with a fine blade. any suggestions/recommendations/warnings?thanks
If you want to use the 11" roll on a Z model you may get in trouble. It is at the edge of the roll width that is accepted. At least on my 44" Z3100 it will not be accepted.http://www.pigment-print.com/dinklacanvaswraps/index.html
I've gone through at least 4 100' rolls of hand cut 11" paper on my 24" Z3100, no problems. Make sure you're using the latest firmware, as there was an update a year or so ago to accommodate this.Mike