did a complete re-install of system, LR and the adobe suite.....the line is still there in LR and CR......not in C1.....not sure i understand.....looking over older files which do not show the line in LR or C1.....
trying to isolate the problem, but i am lost....
[a href=\"index.php?act=findpost&pid=118554\"][{POST_SNAPBACK}][/a]
I reported earlier in this forum about seeing a center line (or two images panels joining) from P45 and LR, but not in C1.
It is my conclusion, no one from Phase One or my dealer will agree or disagree, that all image sensors have this problem in different degree. Phase One handles this much better than other with their C1 and the individual image sensor calibration file done in factory. I don't think the raw file converters from Adobe (both LR ad ACR) has access to this information.
Phase One, according to my dealer, delivers a total solution; DB with C1. Therefore, if you see a line with other software, they will not even talk to you. If you see a line with C1, they will take care of it. At least one P45 user emailed me (after he saw my thread from this forum) that he saw line with C1, and Phase One replaced it immediately and he did not have problems so far.
I believe when Adobe officially supports Phase One DB, they will have access to the know how of using 'sensor calibration file.'
Again, this is my personal conclusion.
Jae Moon