IF that results in a match fine. BTW, what did you measure the Ottlight with? As for 6500K, did you look at the spectrum?
Hi digitaldog, thanks for your reply!
Ok, then i'll try to match the white point of my Ottlight. Let's see if the greys are more neutral then...
I'm measuring it with my EyeOne display2 in Eye-One match.
[attachment=10839:ott.jpg]
But then my white point is not as recommended in the ISO3664?
[attachment=10841:ISO3364_...SO_12646.jpg]
source:
http://www.creativepro.com/article/the-dar...omeback-part-2-I'm a little bit "white point" confused.
So i don't need to worry about the white point of working spaces, and it's allowed to have a white point more close to that of my ambient light/ottlight.
But then i don't meet the ISO3664...
Eventually i want to achieve what is specified in the ISO and have a good match between my prints and monitor.
I was hoping that it was possible with this HP monitor...
Your question about the spectrum of the 6500K, did you mean the the spectrum of the white point of my monitor after calibrating towards 6500K?
If that is the case, i think this is only possible when i would have an eye one Pro and Eye-One Share...?
Kr,