Raw & Post Processing, Printing > Printing: Printers, Papers and Inks
Printer Epson Stylus R2400 rubber rollers cleaning necessary
(1/1)
spassig:
Hello
I have this printer.
I havenˋt use the printer very often in the past for fine art printing.
The printer have three paper entries.
Front, top, back.
It works well with paper in top.
I have problems with Glossy paper in back.
I can use Matte paper in back with little pressing on top of paper.
I think the rubber rollers not in good conditions.
Is anywhere a scetch of printer where I see the rubber rollers in the printer.
Thanks a lot for feedback
Jochen
PS:
I would use this printer because I have lot of ink.
I would use this printer for gain experience fine art printing, ICC profiles and so on.
spassig:
I found this scetch.
I'm not shure wich roller is accountable for feeding papers in printer.
No problems for automatic feeding on top of printer.
Problems for manuell feeding glossy paper with rear feeding shaft.
Jochen
spassig:
Further Info
A) Paper: Sigel Glossy, 170 g/qm, thickness approx. 0,21 mm works.
B) Paper: Epson Ultra Glossy, 300 g/qm, thickness approx. 0,31 mm don't work.
C) Paper: Hahnemühle Glossy FineArt, 325 g/qm, thickness approx. 0,42 mm don't work.
To A) The printer grasp the paper shortly and pulls it inside and I can start the job after order in CaptureOne.
To B) and C) The printer grasp the paper shortly but don't pull it inside and the red light flashing.
A test with mediajet Matt 250 g/qm works.
Jochen
Navigation
[0] Message Index
Go to full version