Raw & Post Processing, Printing > Printing: Printers, Papers and Inks

Cold Mounting tissue?

<< < (2/4) > >>

Larry Heath:
In the for what it’s worth column here is the roll film I use, is a 0.5 mill poly carrier double sticky with single release liner.

http://www.usi-laminate.com/store/wpbec_viewItem.asp?idProduct=3602&search=cold%20mount%20tisser

164’ by 41” on 3” core. 222.70/roll

From http://www.usi-laminate.com/

It has worked quite well for me, on my manual 45” laminator roller. I’ve done both glossy and textured fine art papers with this material, again no problems. Mostly I just make 40” sticky boards and cut to appropriate size. I use Gator Board so I can’t say how this material would work with Sintra from first hand, but I expect it would work just fine.

Later Larry

disneytoy:
Thanks Larry, I just wanted advice from someone's first hand experience.

Maxi

Ernst Dinkla:
If you want specific descriptions; I use Zenith KKD and KKDV for resp. RC and matte Fine Art papers. On DiBond quality panels and rag mounting board. It will be harder to find the Zenith mounting adhesives in the USA so I did not include their names in the first message.

The company has good instruction videos:
https://www.youtube.com/watch?v=cmYSL3j7XXs


Met vriendelijke groet, Ernst

http://www.pigment-print.com/spectralplots/spectrumviz_1.htm
December 2014 update, 700+ inkjet media white spectral plots

disneytoy:
I'm on a budget. I'm about to buy an ebay 39" Cold Laminator. I have a 44" printer. I'd prefer one that I could mount 44" wide prints in the future but the cost goes up quite a bit over the 39" 1 meter version.

I checked out the Drytac MediaTac adhesive recommended by Larry. Are there any less costly products? I think the one recommended cost $222 a roll.

i'm not high volume.

disneytoy:
Thanks  Ernst!

I've watched all those videos. They are excellent. he makes it look so easy.

Navigation

[0] Message Index

[#] Next page

[*] Previous page