can't process w/Capture One 7

[marcmccalmont]

I can't figure out how to set the source so that CO7 will process my files?
Marc

[marcmccalmont]

rebooted the computer Fixed!
Marc

[ErikKaffehr]

Hi Marc,

Once on a flight they rebooted the airplane. Odd experience. Unfortunately it did not help ;-)

Best regards
Erik

rebooted the computer Fixed!
Marc

[Bart_van_der_Wolf]

Once on a flight they rebooted the airplane. Odd experience. Unfortunately it did not help ;-)

Ha, I also had that happening once, it was the best that Boeing/Seattle in an emergency call could come up with, a cold reboot. Fortunately we were still on the ground After switching off all electrical power, they hoped that the faulty 2nd autopilot relais would initialize okay, and it did.

Cheers,
Bart

[marcmccalmont]

Once I was flying a Dornier regional jet and rebooted it on the ground, never had to in the air!
In my current plane the 777 everything is electric even the flight controls!
Marc

[ErikKaffehr]

Hi,

Sorry, I should have been more precise. What happened was that we taxied to the runway, where they decided to reboot the plane.  They still got a bad indication after reboot, so we went back to the gate for an hour or so. So they didn't reboot the airplane in flight.

Best regards
Erik

Ha, I also had that happening once, it was the best that Boeing/Seattle in an emergency call could come up with, a cold reboot. Fortunately we were still on the ground After switching off all electrical power, they hoped that the faulty 2nd autopilot relais would initialize okay, and it did.

Cheers,
Bart

[Paul2660]

One thing to remember is that if a file has been opened previously with Capture 6, and you open it with 7, the default engine will be Capture 6.  On a new file never opened by Capture 7, the engine defaults to 7.  If you have a file that is showing the engine as Capture 6, you can change it in the preferences section (windows version). 

Paul

[EricWHiss]

Back to C1 v7.   I can't process any images either.  I've restarted the computer but its not helping.  Any other ideas?

[EricWHiss]

Okay, I added the batch tab to my tool tabs and this problem is resolved.