Luminous Landscape Forum
Raw & Post Processing, Printing => Capture One Q&A => Topic started by: Jens Peermann on January 10, 2015, 03:18:32 pm
-
I try to apply a user style to a selected image. The moment I click on the style I want, the selection jumps to the last image in the browser and the style is applied to that one. Happens every time, consistently.
-
Jens,
I tried this with C1 v8.1 on two different machines under both Windows 7 and Windows 8.1 and was unable to reproduce your problem with either.
Not much help I'm afraid, but it may suggest a problem with your specific system or installation.
Cheers,
Malcolm
-
I am running C1 on Win 8.1 on under Parallels on a Mac. I can't use the Mac version of C1 because it requires OSX 10.9 and my 1st Generation Mac Pro doesn't run anything later than OSX 10.7.
This may be a bit unusual, but I don't see how it could affect the behavior of C1.
-
If no one here has had a similar experience, then create a case at Phase One. Life is short, time is of the essence, get the answer from those who should know.
-
Did you do a clean install for this update? I had a few strange reactions after installing v8.1 and did everything I could do to figure out why and something Doug Peterson said several times in the past clicked so I did a clean install and problems solved. Yosemite changes the clean install procedure slightly so read the blogs about directions. good luck.
-
Thanks gdh. I did a clean install and it solved most little problems and inconvenience. However, A big problem persists. I will start a new topic for that one.
Thanks again,
Jens