Luminous Landscape Forum
Site & Board Matters => Luminous Landscape Video => Topic started by: Rob Stone on December 19, 2011, 05:14:44 pm
-
I would like to know what viewing booth Michael is using in the Camera to Print & Screen video. I particularly like are what I think are magnets that are used to put the prints up on the vertical surface of the booth.
Thanks in advance.
Rob
-
It's from GTI (http://www.gtilite.com/).
Michael
-
Michael,
Thanks for info on the manufacturer. Is it the Vertical Print Inspector (VPI 40 or 52)?
Rob
-
It's an older model from about 6 years ago. Just go with what suites you best.
-
Thanks, Michael.
Rob
-
A question for Michael.
In a somewhat related question to the topic, may I inquire as to where did you get the magnetic balls that you use to hold up the prints?
-
They are from a local speciality hardware store in Toronto. Lee Valley Tools.
Michael
-
http://www.leevalley.com/en/wood/page.aspx?p=45088&cat=1,42363,42348
In case anyone's wondering...
Mike.
-
Thank you Michael and Mike! I'll have to see if there is something simllar around here in Minneapolis. If not, I'll contact Lee Valley.