Luminous Landscape Forum
Raw & Post Processing, Printing => Digital Image Processing => Topic started by: Dinarius on May 30, 2008, 03:29:49 am
-
In ACR4 I regularly use the retouch tool to remove spots from a single image.
I then apply these changes to a collection of images shot at the same time.
This is indispensible when shooting against a coved background in a studio where any sensor dust/spots is immediately visible.
Is it possible to do something similar with the Spot Healing Brush Tool in CS3?
Would I have to write an action to do it?
I'd like the option because it would allow me to process TIFFs in software other than ACR4.
Thanks.
D.
-
Nope...
-
Thanks for the reply.
So, just to be absolutely clear about this.........the *only* way to apply a set of spot/dust removals on one image to an entire folder of images is via the retouch tool in ACR4. Right? Even if I was willing to use something other than the Spot Healing Brush Tool - e.g. the Clone Stamp tool?
Sorry for labouring the point, but the ability to process in software other than ACR would be attractive occasionally.
Thanks again.
D.