Luminous Landscape Forum

Raw & Post Processing, Printing => Printing: Printers, Papers and Inks => Topic started by: Garnick on August 14, 2015, 12:10:52 pm

Title: Epson 9900 Service Code - D130
Post by: Garnick on August 14, 2015, 12:10:52 pm

Has anyone seen this code and what is it in reference to?  I have seen it a couple of times when entering Service Mode and thought perhaps I hadn't held down all of the necessary keys as firmly as needed.  The information included suggests a restart, and if that doesn't work, a Service Call.  The restart has always worked, so far.  Recently I saw it after starting in Standard Mode following a K ink swap in Service Mode.  Any ideas?

Gary

Title: Re: Epson 9900 Service Code - D130
Post by: cybis on August 14, 2015, 11:00:58 pm

Hi Gary, I've never encountered that error code but the service manual says:

"This is a debug error that occurs at product development. In principle, it does not occur for mass-produced products; however, it might occur due to unexpected causes such as external noises.

1. Restart the printer. If the error does not occur, observe the printer for recurrence.
2. Re-install the firmware.
3. Replace the Main Board Assy."

Also I would try unplugging the printer for a minute and see if the error comes back.