Luminous Landscape Forum

Raw & Post Processing, Printing => Digital Image Processing => Topic started by: ErikKaffehr on May 02, 2010, 02:43:59 pm

Title: Content avare
Post by: ErikKaffehr on May 02, 2010, 02:43:59 pm

Hi,

This is an example of content aware fill:
[attachment=21786:Screen_s...35.21_PM.png]
[attachment=21788:Screen_s...36.24_PM.jpg]

Essential steps:

1) Created a path around the bush
2) Made the path into selection (feather 2 pixels)
3) Pressed delete and used "content aware fill"

Conclusion:

It works in this case. Some artifacts can be seen, but probably not obvious if you don't know what to look for. Your mileage may vary...

Best regards
Erik

Title: Content avare
Post by: bill t. on May 02, 2010, 06:21:09 pm

Pretty good.  Of course your eye zooms right in to artifacts when you know they're there, but give it a week or two and even you notice them.

But branches against water are too easy.  Where's the girl on the rock at lower right?

Title: Content avare
Post by: jerryrock on May 02, 2010, 09:00:40 pm

I find the content aware healing brush to be more accurate for small selections as in the example image.

Title: Content avare
Post by: AndrewKulin on May 05, 2010, 07:41:54 am

Have you tried seeing what happens if you apply content aware a second time selecting only areas with the artifacts?

Title: Content avare
Post by: Jack Flesher on May 05, 2010, 09:58:42 am

FWIW, I find that using the content aware fill for a global correction then following up with the content aware healing brush to edit the artifacts left over from the fill works pretty darn well.