Luminous Landscape Forum

Equipment & Techniques => Medium Format / Film / Digital Backs – and Large Sensor Photography => Topic started by: fabiofotomoto on February 03, 2010, 05:04:55 am

Title: Eyelike M22 precision
Post by: fabiofotomoto on February 03, 2010, 05:04:55 am

Hi
one of my nightmare is the dead of my old PowerMac g5, because seems the eyelike software doasnìt run under the intel mac.!
Today i have done  a test, i installed the eyelike software on a intel g5 with snow leopard. The installation gone! after that i connect the back to an hasselblad 500 and i run the software. I was able to create a new gallery and take shots, rename the file and tranfer them to open with photoshop. I close the gallery and reopen it. all runs well. I open the gallery even off line and it run ok. So, i have no tested with my wiew camera and schnider eletronic shutter, but what i can say,  we ,with this old back no more followed by sinar, have an hope for the future
ciao Fabio

Title: Eyelike M22 precision
Post by: Dustbak on February 03, 2010, 08:10:50 am

The software runs fine under Snow Leopard on my MacPro.

Title: Eyelike M22 precision
Post by: fabiofotomoto on February 03, 2010, 02:19:07 pm

Quote from: Dustbak

The software runs fine under Snow Leopard on my MacPro.

have you tested with multi shot too?
thanks Fabio

Title: Eyelike M22 precision
Post by: Dustbak on February 03, 2010, 02:27:37 pm

Quote from: fabiofotomoto

have you tested with multi shot too?
thanks Fabio

I cannot yet, I need the control cable to get the back to work with my Rollei Lenscontrol S. The back is going back to get it to work with my H1 & Lenscontrol S. Single shot works fine, I have no reason to suspect multishot wouldn't but I have not been able to test that.