Luminous Landscape Forum
Raw & Post Processing, Printing => Printing: Printers, Papers and Inks => Topic started by: jimcamel on January 04, 2009, 06:22:24 pm
-
I bought my first 2 packs of 13x19" Ilford gold fibre silk yesterday (yes Michael, I paid attention to Camera to Print) .... and I was struggling with the media handling on the Epson 4800. I could not use the rear manual feed (it just wouldn't load) - and I didn't think it would ever work coming from the sheet tray ... so I did the manual FRONT load procedure. Is this what most users are doing ? Or, is there another way to load the paper that would work better. BTW I did notice some smudging at the trailing edge - I trimmed it off to balance the print anyway - but would like to eliminate that.
I am trying to print an image on 13x19 that basically leaves a 2" white border on the left and right (and perhaps proportionally smaller on the top and bottom). So, I final size in PS to say 15" x 9" and set the cell size in LR to also 15" x 9".
I am printing from Lightroom using Ilford's ICC profile for the 4800. What settings are you recommending for the Epson driver (Paper Size). I have been doing some test prints using 13x19" matte paper so I don't waste the good stuff by forcing the driver to borderless, Super A3, with Expansion set to MAX- then setting all the borders in LR for it's cell sizes to 0 - that way I can try to centre the image on the physical page. However, it's still off-centre by 1/4". Any better way to do this ? I suppose I could set the top border to .11 of an inch but I think all that will do is scale the image down instead of forcing it down a bit.
thanks for the input
jc
-
I bought my first 2 packs of 13x19" Ilford gold fibre silk yesterday (yes Michael, I paid attention to Camera to Print) .... and I was struggling with the media handling on the Epson 4800. I could not use the rear manual feed (it just wouldn't load) - and I didn't think it would ever work coming from the sheet tray ... so I did the manual FRONT load procedure. Is this what most users are doing ? Or, is there another way to load the paper that would work better. BTW I did notice some smudging at the trailing edge - I trimmed it off to balance the print anyway - but would like to eliminate that.
I am trying to print an image on 13x19 that basically leaves a 2" white border on the left and right (and perhaps proportionally smaller on the top and bottom). So, I final size in PS to say 15" x 9" and set the cell size in LR to also 15" x 9".
I am printing from Lightroom using Ilford's ICC profile for the 4800. What settings are you recommending for the Epson driver (Paper Size). I have been doing some test prints using 13x19" matte paper so I don't waste the good stuff by forcing the driver to borderless, Super A3, with Expansion set to MAX- then setting all the borders in LR for it's cell sizes to 0 - that way I can try to centre the image on the physical page. However, it's still off-centre by 1/4". Any better way to do this ? I suppose I could set the top border to .11 of an inch but I think all that will do is scale the image down instead of forcing it down a bit.
thanks for the input
jc
Jim,
On my 3800 (with the same Ilford paper), I have problems if I use the rear manual feed system. I switched to the Sheet Feeder and now everything works fine. Also, I set the platten gap to wider.
I'm printing from a Mac and I made custom paper sizes (same sizes as A4, A3, A3+ etc. but with different margins). My prints are correctly centered.
Now, I don't know if my experience could be transposed to your 4800.