Luminous Landscape Forum
Equipment & Techniques => Digital Cameras & Shooting Techniques => Topic started by: stacibeth on March 29, 2008, 01:10:01 pm
-
When shooting architecture or interiors what is the best iso to shoot at for the least amount of noise?
-
The lowest ISO is (AFAIK) always the least noisy, but you have to trade off inherent high-ISO noise vs the noise you get from long exposures at low ISO.
Since digital is almost free to try - why not test this for yourself with your camera and lenses, so you can find the optimum solution for yourself? You'll get much better answers that way.
Also have a look at the long thread in the forum about a noise removal technique.
-
Architecture & Interiors = tripod + lowest electronic ISO
The lowest electronic ISO means native ISO values, no software post-adjust. Typically is ISO100 in Canons, ISO200 Nikons and Sony.
The problem is that if your scene has a high dynamic range (for instance windows through which you want to preserve the information unblown), you can get noise in the shadows even if lowest ISO is used and a good degree of exposure is achieved.
Those cases are perfect for blending images with different exposure values expanding the DR.
This scene was shot 2 times 4EV apart. The highlights outside were saved, but the darker inner areas have no noise at all:
(http://img405.imageshack.us/img405/3886/blend213303iq7.jpg)
With just one shot we would have got to chose: low noise in shadows (left), preserve the outside (right):
(http://www.guillermoluijk.com/article/nonoise/ejemplo1.jpg)
since the DR of the scene is around 11 f-stops and my camera can only capture 8.
-
The lowest electronic ISO means native ISO values, no software post-adjust. Typically is ISO100 in Canons, ISO200 Nikons and Sony.
Very true! I believe the Nikon D3 has ISO's than 200, but 200 is the NATIVE ISO even though the ISO rating goes "lower".
-
Architecture & Interiors = tripod + lowest electronic ISO
The lowest electronic ISO means native ISO values, no software post-adjust. Typically is ISO100 in Canons, ISO200 Nikons and Sony.
The problem is that if your scene has a high dynamic range (for instance windows through which you want to preserve the information unblown), you can get noise in the shadows even if lowest ISO is used and a good degree of exposure is achieved.
Those cases are perfect for blending images with different exposure values expanding the DR.
This scene was shot 2 times 4EV apart. The highlights outside were saved, but the darker inner areas have no noise at all:
(http://img405.imageshack.us/img405/3886/blend213303iq7.jpg)
With just one shot we would have got to chose: low noise in shadows (left), preserve the outside (right):
(http://www.guillermoluijk.com/article/nonoise/ejemplo1.jpg)
What software did you use to combine into an HDR?
since the DR of the scene is around 11 f-stops and my camera can only capture 8.
[a href=\"index.php?act=findpost&pid=185262\"][{POST_SNAPBACK}][/a]