Luminous Landscape Forum

Raw & Post Processing, Printing => Digital Image Processing => Topic started by: Harris on October 12, 2007, 08:10:50 am

Title: Z3100 Skew
Post by: Harris on October 12, 2007, 08:10:50 am

Perhaps this has been discused before and if so I would appreciate being directed to the thread.  I have a 24" Z3100 for about 5 months and until recently the only problems I have had with skew were with sheet paper which is easily corrected.

However recently I am having a serious problem with rolls - paper and canvas.  Sometimes it takes me as long as 15 - 20 minutes before I can get a roll accepted by the printer.  Yesterday I used canvas (Fredrix 901) and it took me over 30 minutes before it was accepted.  BTW, the results were exquisite.

In any event, if there are any suggestions as to procedure or other thoughts (does the machine need service) I would appreciate help.  Thanks,

Harris

Title: Z3100 Skew
Post by: rdonson on October 12, 2007, 08:46:21 pm

Harris,

You might want to consider moving this to the "printers, papers and ink" forum.

Title: Z3100 Skew
Post by: Harris on October 13, 2007, 09:01:23 am

Unfortunately,that is where I had originally intended to post this question.  It got here by mistake. Thanks