Luminous Landscape Forum
Equipment & Techniques => Digital Cameras & Shooting Techniques => Topic started by: kaelaria on September 27, 2007, 12:39:21 am
-
I have some old panoramic landscape prints I want to preserve and duplicate. They are 10"x48 and I will be taking 8-10 frames to stich together to get max resolution. The problem is, they are not in perfect condition, with plenty of thumb crincles, little creases here and there, and the prints have extrodinary grain. The paper says Kodak, but I haven't experienced this kind of paper with it's own terrain before.
The lighting is what's getting me. ONE day I had perfect overcast conditions, setup my rig and got a good 'scan' of one of them. Since then, it's never been able to repeat. Always a shadow somewhere, or an obvious directional light.
I have also tried with my studio equipment - combinations of softbox, umbrellas, bounce, etc. Nothing has been able to hit it perfectly. i can get most of it with a large softbox, but there are always spots catching due to the paper imperfections, curl, grain, etc. I thought I had spilled sand or something on it one time, because when I brought them up, there were speckles everywhere on the top 1/3 of the frames. It was the peaks of the paper grain catching the light.
Anyone have experience with this? Is there something I can put over top like some kind of plexi or film or something to flatten it and kill reflection? Do I need a ringlight?
TIA for any tips.
-
I have some old panoramic landscape prints I want to preserve and duplicate. They are 10"x48 and I will be taking 8-10 frames to stich together to get max resolution. The problem is, they are not in perfect condition, with plenty of thumb crincles, little creases here and there, and the prints have extrodinary grain. The paper says Kodak, but I haven't experienced this kind of paper with it's own terrain before.
The lighting is what's getting me. ONE day I had perfect overcast conditions, setup my rig and got a good 'scan' of one of them. Since then, it's never been able to repeat. Always a shadow somewhere, or an obvious directional light.
I have also tried with my studio equipment - combinations of softbox, umbrellas, bounce, etc. Nothing has been able to hit it perfectly. i can get most of it with a large softbox, but there are always spots catching due to the paper imperfections, curl, grain, etc. I thought I had spilled sand or something on it one time, because when I brought them up, there were speckles everywhere on the top 1/3 of the frames. It was the peaks of the paper grain catching the light.
Anyone have experience with this? Is there something I can put over top like some kind of plexi or film or something to flatten it and kill reflection? Do I need a ringlight?
TIA for any tips.
[a href=\"index.php?act=findpost&pid=142144\"][{POST_SNAPBACK}][/a]
I recently had to shoot product shots against seamless white backround. I found the softest light was in the client's garage with the garage door open. Light was soft, but directional. Not the same problem as yours, but give it a try.
Dave
-
I tried a similar setup in one of my florida rooms, with all the blinds down. Very soft, but when you are exposing over several seconds, any directionality comes through like a freaking flashlight when you stich them all together
I bought a scanner, I'll just go that route.
-
You might still have the problem of the "tooth" of the paper showing up in the scan, but on the plus side, the paper will be flat.
-
The scanner worked
http://sbtontheweb.com/images/panoramic.jpg (http://sbtontheweb.com/images/panoramic.jpg)
All the banding and imperfections are unfortunately in the original