Luminous Landscape Forum

Raw & Post Processing, Printing => Printing: Printers, Papers and Inks => Topic started by: soharaus on June 26, 2026, 10:15:00 pm

Title: Not the printr per se but the table to keep the printer on
Post by: soharaus on June 26, 2026, 10:15:00 pm

This is a hardware of a different kind question. I will be purchasing a Epson Surecolor P5370 printer to replace my tried and trusted 3880. The new printer is quite heavy and bulky. Any particular table (with casters) that the current 5370 users recommend that can support the printer and not take up a lot of space? Especially from standard kit kind of places from IKEA, Crate and Barrel etc. . I am somewhat space constrained so I can't put a large table (like a smaller dining table) to use. Any suggestions would be welcome.
Thanks,
PR.

Title: Re: Not the printr per se but the table to keep the printer on
Post by: dgberg on June 28, 2026, 09:28:17 am

I have a couple of these. Ultra HD Seville Classics. Price is $219.
36x24" and the 5370 fits perfectly.

Title: Re: Not the printr per se but the table to keep the printer on
Post by: soharaus on June 28, 2026, 10:00:18 pm

Thanks Dan. That was very helpful.
PR.

Title: Re: Not the printr per se but the table to keep the printer on
Post by: Simon J.A. Simpson on June 29, 2026, 05:37:59 am

Strangely, my post disappeared.  Here it is again.

I have an IKEA Alex cabinet which is wide enough to take a Canon Prograf 1000 (A2) printer and has six drawers useful for paper, cartridges, etc.  It is very slightly lower than a dining table and has casters so you can move it about if you need to.  Highly recommended.

Title: Re: Not the printr per se but the table to keep the printer on
Post by: soharaus on July 01, 2026, 12:49:04 pm

Thank you Simon. Will Check it out.
PR.

Title: Re: Not the printr per se but the table to keep the printer on
Post by: tcphoto1 on July 07, 2026, 11:35:23 am

I've owned an Ikea cabinet for years, it has a butcher block top and three large drawers with stainless steel front. I had it on casters when I lived in lofts but is stationary since moving into an apartment.