Luminous Landscape Forum
Raw & Post Processing, Printing => Printing: Printers, Papers and Inks => Topic started by: gchappel on December 28, 2023, 07:01:10 pm
-
Fairly new to me canon 4100.
Local printer (friend) is changing inksets and gave me a full set of partially filled 700cc cartridges, pfi 1700.
These are about 1/2 full or so- lots of ink.
I am not sure how this printer monitors ink. Can I safely install a pfi 1700 cartridge that contains let us say 300cc of ink instead of 700cc, and still use ink monitoring, or do I need to monitor useage and check the cartridge weight manually so I don't run it dry?
Just trying to not do anything dumber than usual
thanks
gary
-
Fairly new to me canon 4100.
Local printer (friend) is changing inksets and gave me a full set of partially filled 700cc cartridges, pfi 1700.
These are about 1/2 full or so- lots of ink.
I am not sure how this printer monitors ink. Can I safely install a pfi 1700 cartridge that contains let us say 300cc of ink instead of 700cc, and still use ink monitoring, or do I need to monitor useage and check the cartridge weight manually so I don't run it dry?
Just trying to not do anything dumber than usual
thanks
gary
The apporx. amount of ink is saved in cartridge chip, and PRO-4100 has large ink subtanks, so it basically prints even after it dries out cartridge completly. It only stops printing when ink in subtanks goes below certain level.
-
Now I'm curious... what inkset is your friend changing to and why?
-
Yes my question as well. Why would he change out carts with possibly 3000ml of unused ink remaining? This stuff has an almost unlimited lifespan. I did say almost!
-
Thanks, wanted to confirm it monitors at the subtank level, and not the cartridge.
I'll ask about the ink--- not sure why he tries a lot of stuff he tries.
gary