Luminous Landscape Forum

Raw & Post Processing, Printing => Colour Management => Topic started by: Thenolands on September 01, 2018, 12:13:14 pm

Title: Preset Colorchecker Passport and/or QP card corrections?
Post by: Thenolands on September 01, 2018, 12:13:14 pm

For anyone who uses colorchecker passport and find it a bit too saturated and possibly a little too red (like me) do you have any default adjustments you make to the profile it creates? I realize you may then make individual adjustments for a particular image but do you have adjustments you always make to get close to the output you want?

Also, same question for QP Card users.

Title: Re: Preset Colorchecker Passport and/or QP card corrections?
Post by: DP on September 01, 2018, 12:19:37 pm

Quote from: Thenolands on September 01, 2018, 12:13:14 pm

For anyone who uses colorchecker passport and find it a bit too saturated and possibly a little too red (like me) do you have any default adjustments you make to the profile it creates? I realize you may then make individual adjustments for a particular image but do you have adjustments you always make to get close to the output you want?

Also, same question for QP Card users.

standard answer for such questions - read the following and use alternative tools vs X-Rite's or QP (which is [ A ] long dead and [ B ] quality of their targets is horrible ) - tools like dcamprof allow you way better control over profile creation - so that you will not waste time during raw conversion/post processing :

http://www.ludd.ltu.se/~torger/dcamprof.html

https://www.ludd.ltu.se/~torger/photography/camera-profiling.html

http://www.lumariver.com/lrpd-manual/

and

megathread @ LuLa = https://forum.luminous-landscape.com/index.php?topic=100015.0