Luminous Landscape Forum
Raw & Post Processing, Printing => Printing: Printers, Papers and Inks => Topic started by: namartinnz on January 10, 2017, 05:30:34 pm
-
Hi everyone
I've got a 44.1 error on my Z3200. If it's the same code as the Z3100 I assume it's something to do with the fan or printmech PCA? Are these relatively easy to fix?
Cheers
Neal
** Update **
I Decided to open the printer up and found a gunked up fan. A quick whirl, wipe down and wiggle some wires and it's all good again for the time being. I'll likely need a replacement at some stage.
-
Here's how to fix your fan:
Replacing the Z3200 Fan (http://robogravure.com/HPZ3200_Repair_Notes_Mark_Lindquist_Photography.htm#REPLACING_THE_HP_Z3200_POWER_SUPPLY_UNIT_(PSU)_FAN_)
Might as well start ordering the fan -it's inevitable.
Not too bad if you take it slow and easy.
-
Here's how to fix your fan:
Replacing the Z3200 Fan (http://robogravure.com/HPZ3200_Repair_Notes_Mark_Lindquist_Photography.htm#REPLACING_THE_HP_Z3200_POWER_SUPPLY_UNIT_(PSU)_FAN_)
Might as well start ordering the fan -it's inevitable.
Not too bad if you take it slow and easy.
Mark you have become the Z- repair man!
With my Z3100 the first thing that broke down was the fan... but it is easy to replace.
A save start for getting to know the machine.
-
Mark
This was the fan at the other end beside the ink station and would be very easy to replace. Fingers crossed the power supply fan won't need fixing for a long time
-
that looks bad from the ink
-
Yes I think the service station will need to be replaced/cleaned up soon. When I put the rhs cover back on yesterday, ink started pouring out of it. Overflow I think and was likely in the cover but I didn't see it originally. I have my old z3100 station so will look if I can use it as a future replacement