Luminous Landscape Forum
Raw & Post Processing, Printing => Printing: Printers, Papers and Inks => Topic started by: rebadurchee on November 18, 2015, 03:33:50 pm
-
A message has appeared on my 3880's LCD and in Status Monitor on my screen saying my maintenance cartridge has to be replaced SOON. It shows about 8% capacity left and that I can continue printing until the message says it must be replaced.
However, it won't print. Nothing I do, from pressing the OK button on the printer or the Stop button on the Status monitor will convince the printer to print. If I repeat my futile steps enough times the printer will start, but will only print about 1/2" of the photo and then eject the whole sheet, wasting some very good paper.
What am I doing wrong? The Epson manual only tells me how to replace the cartridge, but I'd rather not until it is full. Any suggestions would be greatly appreciated.
Thanks,
Stilson
-
You could try reseating the maintenance cart. But if it were me I'd just go ahead and replace it with a new one. They're only about $20.
-
All of those percentages are just guesses based on prints done. They are not really accurate. It is just to let you know to get a new one for when it stops.
I just keep going until that happens.
Taking out and putting back will probably fix it for a short time.
-
Thanks for the suggestions! I figured out I was trying to save $3-4 at most by not just replacing it. I could easily have ruined much more than that in paper trying to be cheap. So I replaced the cartridge and now everything works fine. I did notice, however, that a large swath of the maintenance cartridge did not have any ink in it at all. Oh, well...