Luminous Landscape Forum

Raw & Post Processing, Printing => Printing: Printers, Papers and Inks => Topic started by: jtunney on May 16, 2015, 10:42:25 pm

Title: buckled prints
Post by: jtunney on May 16, 2015, 10:42:25 pm

Does anyone have a method to unbuckle prints?

Thanks.

Title: Re: buckled prints
Post by: hugowolf on May 17, 2015, 11:40:52 pm

A hot press, usually used for dry mounting, works. Especially if you dampen the back with distilled water, using a barely damp sponge.

Brian A

Title: Re: buckled prints
Post by: dseelig on May 18, 2015, 02:59:26 am

go to home depot but  a roll of paper that is used to be under wood and you can buy it for 20 bucks and workd like a droller Iput in my prints in plastic beofre I roll it in it.

Title: Re: buckled prints
Post by: Ernst Dinkla on May 18, 2015, 10:44:10 am

Decurl or debuckle; a curl in one direction or 3D deformations all over the print?

If it is the last Brian's solution might work, never done it. Gluing/laminating the print in total on a rigid mounting board is probably the most promising solution.

Met vriendelijke groet, Ernst

http://www.pigment-print.com/spectralplots/spectrumviz_1.htm
December 2014 update, 700+ inkjet media white spectral plots