I'm having a problem here. I have never had this problem before but today I tried to print an image at 20x28 and when the printer started, it was only printing an image about 6 " across. I went back and looked over ALL the settings and every one had the size correct. Even the print with preview window had the image the correct size compared to the paper size I had requested. I tried shutting everything off and restarting hoping it would reset itself but, no luck. Anyone out there ever have this happen? I run a Mac and PSCS2.
I am having the same problem. In reply to the question on the lower part of this page, my printer is only printing a partial of the entire image. It seems to select an area of approx. 1/4 of the entire image and "throws" that small portion to the lower right corner of the paper. In addition, the paper is "rolled" back too far, not allowing a proper white border around the image. If I have requested a 2" border, I am given a 1/2" border at best. Am exasperated! This same printed operated beautifully powered by a pc in another location. I am using a mac with a newly installed cs2 package. Would greatly appreciate any suggestions! Like your window, the print preview illustrates everything as I would like it to print. Thank you! Radford