Luminous Landscape Home
Luminous Landscape Forum > Raw & Post Processing, Printing > Printing: Printers, Papers and Inks > Can I use Ergosoft software on Mac - Boot Camp, Parralels?
Pages: [1]   Go Down

Author Topic: Can I use Ergosoft software on Mac - Boot Camp, Parralels?  (Read 1575 times)

Sunshine7

  • Newbie
  • *
  • Offline Offline
  • Posts: 46
Can I use Ergosoft software on Mac - Boot Camp, Parralels?
« on: January 18, 2015, 12:41:30 pm »
Hi All,

Does anyone know if I can run Ergosoft Studio Print or Texprint on a Mac?

Maybe using Boot Camp or Parallels? What has been your experience with this?

Would appreciate any help with this, could not get hold of Ergosoft so far.

Thanks!
Logged

aaronchan

  • Sr. Member
  • ****
  • Offline Offline
  • Posts: 617
Re: Can I use Ergosoft software on Mac - Boot Camp, Parralels?
« Reply #1 on: January 18, 2015, 01:13:00 pm »
Not sure but I think it should work.
But I do always advise my clients to run the RIP software on a dedicated computer.

aaron
Logged

Sunshine7

  • Newbie
  • *
  • Offline Offline
  • Posts: 46
Re: Can I use Ergosoft software on Mac - Boot Camp, Parralels?
« Reply #2 on: January 18, 2015, 02:48:04 pm »
Yes, that makes sense!

This is only for one print job to start with, possibly printing one file 100 to 200 times if I can get this to work on a Mac, after this I will get a dedicated windows machine for this. During the printing time only the RIP will be running and the machine will not be used for anything else.

Logged

macz5024

  • Jr. Member
  • **
  • Offline Offline
  • Posts: 56
    • http://www.markuszuber.com
Re: Can I use Ergosoft software on Mac - Boot Camp, Parralels?
« Reply #3 on: January 19, 2015, 06:03:00 am »
Studio Print 12 runs fine with Windows 7/64 on a MacPro (Mavericks) and Parallels 9 or 10.
Logged

Sunshine7

  • Newbie
  • *
  • Offline Offline
  • Posts: 46
Re: Can I use Ergosoft software on Mac - Boot Camp, Parralels?
« Reply #4 on: January 19, 2015, 02:05:21 pm »
Thanks!
Logged
Pages: [1]   Go Up
Luminous Landscape Forum > Raw & Post Processing, Printing > Printing: Printers, Papers and Inks > Can I use Ergosoft software on Mac - Boot Camp, Parralels?