Hi,
I am trying to setup HD39-II back to work on a view camera and it does not work. Connected a copal shutter to a digital back using a cable similar to this:
https://captureintegration.com/wp-content/uploads/2012/08/LongSync503000741.jpgThen connected DB to computer with Phocus... It recognized back, and all looks OK. But it did not trigger a shot when I press a shutter release on a view camera.
Is there any additional steps I am missing? The same configuration works with with Leaf aptus 75 back.. and Hd39 works OK on a Hd3 camera body.
Any help/suggestions?
Thank you in advance!
P.S found on Hasselblad website , this is what I am trying to do:
General Connection Options - Manual Flash Sync
A method is required to physically trigger the lens shutter and the
digital back simultaneously. This can be done via a very simple flash
sync connection or via a sophisticated electronic interface.
Using a manual copal type lens, connection is made from the lens
flash sync to the Sync In port on the digital unit. Therefore when the
exposure is triggered on the lens, the digital unit receives a signal to
expose simultaneously. If flash lighting is required then connection is
made from the Sync Out port on the digital unit to the flash equipment.