Thanks for the file.
I printed it using the same parameters and paper. Results are the followings:
- Looks pretty good in general (i.e. no strong dominant orange cast)
- In general, it printed slightly darker than on my display (just recalibrated at 80), no problem there
- all grey patterns are OK except the largest one, in the middle right-hand side which displays some right-to-left patterns (horizontal). This grey pattern looks a bit more orange-red than the other (which all seem to have a very slight orange pattern, or maybe it is only because they are little darker)
- In the center left-hand side large colored square, I almost don't see the difference of colors between:
(a) upper-right hand top corner small salmon polygon vs adjacent larger orange polygon
(b) middle-top left-hand side red narrow band polygon vs adjacent larger pink band polygon
(c) top left salmon corner looks more orange
(d) lower right violet corner looks more red and is more difficult to differentiate from the adjacent red polygon
I used a OttLite Lamp for natural lighting when looking the print. I also used Softproof On (right paper target profile + Perceptual intent + Black Point Compensation).
Any hint?
Great web site by the way !