Hi guys
Firstly thanks again for your help over the years!
I've just returned from the UK where I had lived for four years and am now based in Melbourne. Unpacked my printer and whilst I've loaded new heads and cartridges after the first couple of runs calibration etc the printer started to make some clunky noises and I got paper jam and other notices which won't resolve. On review of the calibration I noticed some rubber bits. I've had a lucky run with my 2007 printer but figure the belt drive is gone.
I love the printer, but I'm not an electronic genius and would like to arrange a service/fix up of my printer. Do you which companies might offer on site servicing for this printer in Melbourne?
Advice appreciated!
Mehdi