Pages: [1]   Go Down

Author Topic: Opps... wrong setting  (Read 541 times)

Mike Guilbault

  • Sr. Member
  • ****
  • Offline Offline
  • Posts: 966
    • Mike Guilbault Photography
Opps... wrong setting
« on: May 16, 2013, 12:47:38 PM »

Just made two canvas prints and forgot to change the paper type setting on the 9900.  It was set for Enhanced Matte rather than Canvas.  The prints look ok... but should I be aware of anything?

bill t.

  • Sr. Member
  • ****
  • Offline Offline
  • Posts: 2979
    • http://www.unit16.net
Re: Opps... wrong setting
« Reply #1 on: May 16, 2013, 01:04:03 PM »

IIRC, the inkload for EHM is heavier than for matte canvas.  So maybe let it dry longer?  And the head height is much lower, do you see any swiped canvas peaks?  But hey, it's the right black ink selection, so keep calm and carry on.
Logged

Mike Guilbault

  • Sr. Member
  • ****
  • Offline Offline
  • Posts: 966
    • Mike Guilbault Photography
Re: Opps... wrong setting
« Reply #2 on: May 16, 2013, 03:19:13 PM »

haven't noticed any 'canvas peaks'.  Nothing looks out of place at all.  I'll take your advice though and let it dry longer before coating.
Pages: [1]   Go Up