Pages: [1]   Go Down

Author Topic: Recovering lost detail  (Read 1225 times)

Joe S

  • Full Member
  • ***
  • Offline Offline
  • Posts: 100
Recovering lost detail
« on: January 16, 2012, 10:46:40 pm »

Can someone suggest the best way of recovering lost fine foilage detail against a section of blown out sky in a high ISO image?
Logged

bill t.

  • Sr. Member
  • ****
  • Offline Offline
  • Posts: 3011
    • http://www.unit16.net
Re: Recovering lost detail
« Reply #1 on: January 16, 2012, 11:18:17 pm »

Hard to say without seeing the image or just a section of the image.

But one good technique is go out and shoot some similar fine foliage against a NOT blown-out sky and rubber stamp and/or mask it in.

Or select the the sky, turn the selection into the black section of a mask, and put a properly exposed sky or a sky-like gradation on a layer just underneath.  Lots of techniques to make this work well, your first attempt will be disappointing, but keep on trying.  If your sky is not completely unrecoverable, put your original sky on a layer below the masked foliage but with a radical Curves layer applied to bring out the sky detail, the mask above will hide everything except the sky.  But getting the edges on that mask just right will take some study.

And masks can often be used to sharpen the apparent edges of foliage.
« Last Edit: January 16, 2012, 11:21:30 pm by bill t. »
Logged

Mark D Segal

  • Contributor
  • Sr. Member
  • *
  • Offline Offline
  • Posts: 12512
    • http://www.markdsegal.com
Re: Recovering lost detail
« Reply #2 on: January 17, 2012, 12:11:01 am »

Can someone suggest the best way of recovering lost fine foilage detail against a section of blown out sky in a high ISO image?

Is the detail there to be recovered? Cn you post an image?
Logged
Mark D Segal (formerly MarkDS)
Author: "Scanning Workflows with SilverFast 8....."
Pages: [1]   Go Up