Pages: [1]   Go Down

Author Topic: Phase One H-series sync cable compatibility  (Read 1289 times)

Snapshot

  • Newbie
  • *
  • Offline Offline
  • Posts: 42
Phase One H-series sync cable compatibility
« on: October 12, 2010, 02:25:37 am »

Hi all,

Are Phase One (lens to back) sync cables for the H-series backs (these cables have a flash connector on one side and a mini-jack plug on the other) compatible with Hasselblad/Imacon backs? I need a sync cable for my "new" Imacon 132c back.

Thanks for your help!

Kind regards,
Selmar
Logged

Nick-T

  • Sr. Member
  • ****
  • Offline Offline
  • Posts: 462
Re: Phase One H-series sync cable compatibility
« Reply #1 on: October 12, 2010, 03:37:06 pm »

What are you putting your 132c on to?
Nick-T
Logged
[url=http://www.hasselbladdigitalforum.c

Snapshot

  • Newbie
  • *
  • Offline Offline
  • Posts: 42
Re: Phase One H-series sync cable compatibility
« Reply #2 on: October 19, 2010, 09:18:52 am »

On a Hasselblad V body.

Kind regards,
Selmar
Logged

Weldon Brewster

  • Jr. Member
  • **
  • Offline Offline
  • Posts: 64
    • http://www.weldonbrewster.com
Re: Phase One H-series sync cable compatibility
« Reply #3 on: October 19, 2010, 02:06:13 pm »

I used a Y cable with much success on my old 132c.  I had it made at http://www.paramountcords.com  Basically it works like this:  The long end goes to a mini plug for a flash wizard to trigger the strobe, one end of the y is a pc socket to go to the hassy lens and the other end of the Y is a micro plug to go to the 132c back.  It worked great.  I used it on a Cambo wide ds and a Hassy before I got my Contax.

Good luck,
Weldon
Logged
Weldon Brewster
www.weldonbrewster.com

Snapshot

  • Newbie
  • *
  • Offline Offline
  • Posts: 42
Re: Phase One H-series sync cable compatibility
« Reply #4 on: October 21, 2010, 03:45:08 am »

Thanks for the reactions so far. In the meantime I've found out that any sync cable with a sub mini (2.5mm) jack can be used.

Kind regards,
Selmar
Logged
Pages: [1]   Go Up