Gee thanks Stuart.
I have a ton of festool stuff here,you could even call me a Festool junki!
I watched the video but it ended without them showing what they did when they folded up the corners.
I am surprised I have never seen this tool although the quick search I did only showed Euro pricing.
Almost $1500 US,ouch.
I have the Festool track system with several of their routers.
I just found the dibond v groove router bits online and ordered one,only $35.00
A whole lot less then that $1500.
I will set this all up,run some material and repot back with results.
I can purchase Dibond from my distributor in 2,3 and 4mm thicknesses.
Another thing I forgot to mention on the dibond that has the aluminum strips on both sides.
The installation of these 2 strips eliminates all 4 sharp corners and edges.
A small file over the top and bottom edges takes care of that issue.
I could see someone putting a nice slice on a finger or hand if the edges were not burnished.
The large dibond panel being cut and folded on the video has quite a lot of edges to file.
You are right,so many options.
Thanks for the link.