HELP, I'm off-centered and slightly skewed,

[davi russo]

MY problem:
I am noticing and measuring my prints that are off-centered and slight skewed roughly 2-4mm...
arghhhhh@#$
WHY?

is this a normal acceptable amount of shift offset for printing?
any one else getting shifts,
so annoying
because i am trying to have these prints mounted and framed without mattes to cover the slight offset..

love to hear from ya'll please...
thank you,
-davi


MY Set up:

Printing with an Epson 3880
onto 13x19" Ilford GG media sheets
using one sheet loaded at a time
normal top tray

using LR:
2:3 ratio crops
0.13 in Margin around all edges
Cell Size 18x12 in
to produce a perfect .5 inch white border around print

page setup:
super A3 setup
portrait orientation
100% scale

Print settings:
Media Type Premium Photo Paper Semi-gloss
photo black
color
16bit
no color adjusr
1440dpi

paper configuration:
paper thickness 5
platen gap wide

[CoyoteButtes]

MY Set up:

Printing with an Epson 3880
onto 13x19" Ilford GG media sheets
using one sheet loaded at a time
normal top tray

Try feeding a single sheet through the rear manual feed slot.

Stan

[jerry walker]

MY Set up:

Printing with an Epson 3880
onto 13x19" Ilford GG media sheets
using one sheet loaded at a time
normal top tray

Try feeding a single sheet through the rear manual feed slot.

Stan

I have that problem with my 3880 when I print one sheet at a time.  When I load 3 or 4 sheets there are no problems.  That is using 17x22 paper.

[davi russo]

I have that problem with my 3880 when I print one sheet at a time.  When I load 3 or 4 sheets there are no problems.  That is using 17x22 paper.

Jerry,

thank you for the advice,
i have never tried to load more then a single sheet of anything in the 3880,
so i will def give a 3-4 sheet trial run on my next print run to see how that goes.
thank you for taking the time to reply.
all my best,
-davi

[Wayne Fox]

Jerry,

thank you for the advice,
i have never tried to load more then a single sheet of anything in the 3880,
so i will def give a 3-4 sheet trial run on my next print run to see how that goes.
thank you for taking the time to reply.
all my best,
-davi

As mentioned by Stan, Ilford GGFS should be single fed through the rear manual slot or the front manual slot.  Using the sheet feeder will be a mixed bag and not very reliable.  Since you want a .5 inch border your only option is the rear feeder, I believe the front feeder leaves a top and bottom margin larger than that.

Also it tends to have a slight curl on the front, so a corner can easily snag and skew the paper a little.  Might try to decurl the leading edge.