Uneven borders with Exhibition Fiber on Epson 2880

[jimgoldring]

I've notice that when I print 13x19 with Exhibition Fiber on the  Epson 2880 that my borders are always uneven. Usually on the long axis of the paper--one border very thin or non-existent the other bigger than it should. Never happens with the sheet feeder but only the manual feed which you have to use for this paper. Easy to get around it when matting but sill annoying. Anyone else seen this behavior or know if there is a fix?
Thanks in advance.
Jim

[Richowens]

On the "page layout" page of the printer dialogue check "centered" and "minimize margins".

 That's how I do it on a 2200. I think the later printers are about the same or have an equivalent.

HTH

Rich