Luminous Landscape Home
Luminous Landscape Forum > Raw & Post Processing, Printing > Colour Management > Calibration Sensor Recommedation?
Pages: [1]   Go Down

Author Topic: Calibration Sensor Recommedation?  (Read 1730 times)

ChuckZ

  • Jr. Member
  • **
  • Offline Offline
  • Posts: 59
    • http://czhike88.smugmug.com/
Calibration Sensor Recommedation?
« on: November 12, 2009, 01:21:58 pm »
Per earlier advice, I tried out the ColorEyes Display Pro software instead of the Spyder2express that I was using. I am now getting better results. Next, I figure to replace my Spyder2express hardware with either the Spyder3 or i1display2 sensor. Any advice? Thank you.
(Dell 2408wfp monitor,NVIDIA GeForce 8600GT video card)
Logged

probep

  • Full Member
  • ***
  • Offline Offline
  • Posts: 149
Calibration Sensor Recommedation?
« Reply #1 on: November 12, 2009, 01:32:20 pm »
Quote from: ChuckZ
Per earlier advice, I tried out the ColorEyes Display Pro software instead of the Spyder2express that I was using. I am now getting better results. Next, I figure to replace my Spyder2express hardware with either the Spyder3 or i1display2 sensor. Any advice? Thank you.
(Dell 2408wfp monitor,NVIDIA GeForce 8600GT video card)
i1 Display 2, I think. Buy Spyder3 only if you can measure your Spyder against a known correct meter.
Logged
Pages: [1]   Go Up
Luminous Landscape Forum > Raw & Post Processing, Printing > Colour Management > Calibration Sensor Recommedation?