Pages: [1]   Go Down

Author Topic: Tethered capturing from Phocus with 132c and AFD  (Read 3083 times)

A.K.

  • Jr. Member
  • **
  • Offline Offline
  • Posts: 83
    • http://www.andreykulpin.com
Tethered capturing from Phocus with 132c and AFD
« on: October 30, 2008, 03:30:56 pm »

Hello,
Is there a way to perform a remote capture from Phocus using 132C back and a Mamiya 645AFD body? The camera seems to be not recognized by the software: the back fires but the image is certainly black. In FlexColor the function works correctly — the camera also fires when the capture is performed.    
Looking forward to getting any advice.
Logged
Regards,
 Andrey Kulpin [url=http://www.a

VanKou

  • Newbie
  • *
  • Offline Offline
  • Posts: 46
    • http://www.vankou.com
Tethered capturing from Phocus with 132c and AFD
« Reply #1 on: October 30, 2008, 04:14:28 pm »

Isn't this one of the older backs?  i was told that these older type backs (I have a V96C) are not supported by phocus as far as tethered capture goes...Check with Hasselblad again, yours might be a different story.
Logged

Nick-T

  • Sr. Member
  • ****
  • Offline Offline
  • Posts: 462
Tethered capturing from Phocus with 132c and AFD
« Reply #2 on: October 30, 2008, 04:47:04 pm »

Quote from: VanKou
Isn't this one of the older backs?  i was told that these older type backs (I have a V96C) are not supported by phocus as far as tethered capture goes...Check with Hasselblad again, yours might be a different story.
Not so, I Have a 384 (on an H2) working just fine with Phocus, not sure what the issue could be with the AFD.

Nick-T
Logged
[url=http://www.hasselbladdigitalforum.c
Pages: [1]   Go Up