Hi, I recently acquired a Samsung 213t monitor. I hooked it up using DVI and calibrated it with an i1display2. During calibration the monitor only allows brightness control (no contrast, user color etc.). I went to Samsungs site and found that the monitor only allows the contrast, user color etc. modes when using the VGA input.
So, is it better to use DVI with only brightness control or VGA with the other controls?
During calibration and looking at the RGB advanced mode with DVI hookup the levels were pegged to one side or the other. Will the Disply2 adjust for this good enough?
Also, the contrast was set at 50% (again not adjustable) but was centered during contrast adjustment so no adjustment was needed there anyways.