I just received a Manfrotto Variable friction arm, but teh unit was not assembled. In fact, the washers and nylon ball bearing bushing were int eh bottom of teh large shipping box. it's luck I didn't lose them. Shame on B&H.
Anyway, can someone tell me the correct assembly?
(1) Thick standard spacer like washer.
(2) Thin washers with grooves around one side of their centers.
(1) nylon bushing with small ball bearing embedded into it.
91) Orange rubber/nylon bushing about 1" in diameter with a hole in the middle of it, about 1/8 inch.
Thanks